Technology
VR lip seals
A rotary shaft seal seals a rotating shaft against a housing. Due to its special design, the VR seal ring is suitable for high circumferential speeds and high pressure loads..
Sealing mechanism of the VR seals
The operating mechanism of the springless VR radial shaft seal is based on rubber-elastic membrane bodies being precisely tensioned over support bodies made of stainless steel or other metals. The subsequent sealing lip, arranged at an oblique angle, can point either outward or inward depending on the installation position and the direction of the medium to be sealed.
This mechanism relies on the radial and tangential pre-tensioning of the membrane body, resulting in a spring-like effect between the membrane body and the sealing lip. Consequently, both radial and tangential forces acting on the sealing lip are balanced in rotating shafts, thereby reducing resulting shear stresses. Vibrations as well as static and dynamic runout deviations are directly absorbed in the area of the sealing lip. The design of the seal minimizes the partial lifting of the sealing lip in rotating shafts and the associated pumping effect.
Comparative measurements have shown that the VR seal requires only 1/3 to 1/4 of the radial force compared to the worm spring-supported sealing element while maintaining the same sealing performance. This contributes positively to the energy efficiency of modern products.
VR advantages
- Pressure resistant
- Friction-optimized & energy efficient
- For high circumferential speed
- For narrow installation conditions
- For demanding applications
- Reduced so called pumping effect due to tangential and radial pre-tensioning
- Reliable sealing on unhardened and stainless steel shafts*
- No damaging wear tracks*
- No post-treatment of the shaft material required, such as hardening, nitriding, hard chrome plating, or additional running sleeves*
*Applies only under corresponding operating conditions; please consult for higher pressures and circumferential speeds or with abrasive media.
VR standard seals
|
Property
|
Unit
|
Value
|
|---|---|---|
|
Vmax*
|
m/s
|
40
|
|
Pmax*
|
MPa
|
1.5
|
|
Temperature range**
|
°C
|
-50°C - 260°C
|
|
Temperature range**
|
°F)
|
-58°F - 500°F
|
* not simultaneously
** Choose corresponding elastomer. Contact us for challenging applications
|
Property
|
Unit
|
Value
|
|---|---|---|
|
Vmax*
|
m/s
|
40
|
|
Pmax*
|
MPa
|
15
|
|
Temperature range**
|
°C
|
-50°C - 260°C
|
|
Temperature range**
|
°F)
|
-58°F - 500°F
|
* not simultaneously
** Choose corresponding elastomer. Contact us for challenging applications
Sealing Environment
A complex system of mutually influencing variables has an effect on the sealing behavior and service life.
(1) Housing
- Surfaces
- Tolerances
- Material
- Center offset to the shaft
(2) Shaft
- Surfaces
- Diameter
- Speed
- Eccentricity
- Material
- Axial movement
(3) VR sealing ring
- Radial force
- Construction and tolerances
- Material
- Hardness
- Wear resistance
- Frictional properties
- Resistance to swelling and shrinkage
Medium
- Chemical effects
- Viscosity
- Pressure
- Decomposition products
- Lubricity
Environment and operating mode
- Temperature
- Dust and dirt
- Cleaning agents
- Running and standstill periods
